![]() WARNING! TO PREVENT SERIOUS INJURY: Verify that installation surface has no hidden utility lines before drilling or driving screws. Note: An optional 6 volt, 200 mA power adapter (not included) can be used to power the Receiver instead of batteries. Using a screwdriver (not included), remove the Battery Cover of the Receiver, and insert three C batteries (not included).Using a screwdriver (not included), remove the Battery Cover of the Sensor, and insert one 9V battery (not included).It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur.This will ensure that the safety of the power tool is maintained. Have your power tool serviced by a qualified repair person using only identical replacement parts.If there is any doubt, do not set up the Light. ![]() ![]() Read warning labels on prescriptions to determine if your judgement or reflexes are impaired while taking drugs. Do not set up the Alert System if under the influence of alcohol or drugs.If a ladder is to be used during installation, it should be supported by an assistant. Keep proper footing and balance at all times. If damaged, have it repaired by a qualified technician. Keep the Alert System clean for better and safer performance. Wear ANSIapproved impact safety goggles when setting up this product. Wear restrictive hair covering to contain long hair. Protective, electrically non-conductive clothes and nonskid footwear are recommended when working with the Alert System. Mount the Sensor and Receiver out of children’s reach. Use of any other parts will void the warranty. When servicing, use only identical replacement parts. Do not use the Alert System if any switch does not turn on and off properly. Replace or repair damaged or worn parts immediately. Check for any broken or damaged parts and any other conditions that may affect its operation. Before using any product, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Keep work area well lit during installation. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. Save all warnings and instructions for future reference. Read all safety warnings and instructions.įailure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. 8.1 Related Manuals / Resources IMPORTANT SAFETY INFORMATION ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |